Setting up a correction link - Arducopter integration?

[rcdevil (FRED)]

Dear Mikhail,
here is my cable connection:

Wiring Reach M2 with Cube Pilot Orange Cube

Hello together, i´m trying since days to get an signal from the reach M2 into my Arducopter Orange cube into my second GPS2 port. All setting from the emlid doc site right done, but no signal. Now my question: Who has succesfull maked this? What is the right wiring between Reach M2 and Orange Cube module? GPS2 port on orange cube must go RX (orange cube) to TX (reach m2)? must go TX (orange cube) to RX (reach m2)? and ground to ground blue marked wires not necessary? [grafik] Wiring …

I have connected a separate power source to pin 5 V and ground. The Reach M2 module also starts and can also be accessed with Reachview.
In addition, I also tested the original connection cable from EMLID, also the same result, no GPS signal on the GPS2 port from Pixhawk.

Reach M2/M+ JST-GH 6p-6p cable for Pixhawk 2 - Emlid Store

But I get GPS injection signal in.
If you wish, i can send you Mission Planner settings file.
Thank you very much.