ReachView v2.14

News
2

AWESOME!!!

You guys are genuinely AWESOME! Thank you! Such a great company, products and people (and community!)!

5 Likes
3
4

Hi.

So continuing with the features of the previous dev version.
In this new stable version should Glonass Ar always be on?.
The mask down to 5, should be gradually once you get “fix” or lower it from the beginning ?.

Regards

1 Like
5

15 posts were split to a new topic: Reported baseline distance vs. measured

6

A post was merged into an existing topic: Reported baseline distance vs. measured

7

The continuous mode must be in the two antennas (base and rover)? Or only in one of them (Base=fix and hold, Rover=Continuous)?.

I would appreciate your help

Regards

8

The choice between RTK settings, like that of fix-and-hold and continuous is one that is made during processing. When you are actually doing RTK, that choice is made at the rover end. When doing PPK processing (after data collection), then that choice is made afterward in the processing software.

A simple rule is that for your base station, the only settings under the ‘RTK’ tab that you should be concerned with are these two:

  • GNSS systems (GPS, GLO, GAL, etc., etc)
  • sample rate (1Hz, 5Hz, 10Hz, 14Hz)

They matter for both RTK and PPK.

*Now, the exception is if you are calculating your base’s coordinate by using an NTRIP connection, then your base is also acting as a rover. In that case my rule does not apply.

3 Likes
9

We recommend to set Glonass AR to on always starting from v2.14.0. We plan to remove this setting at all starting from next stable update if there are no reports of issues. Mask down to 5 can be from the very beginning.

4 Likes
10

@igor.vereninov, are there plans to make AR available for the Galileo system? Seems to be the only missing major system, at least in RTKlib.

2 Likes
11

@wizprod it is already in there and working by default. Glonass was just more tricky and it took us some time to crack it.

We recommend to always use 3 main systems for RTK. GPS+Glonass+Galileo or GPS+Beidou+Galileo. All of these systems are supported for AR now and even with mixed receivers (for example when getting corrections from NTRIP station).

3 Likes
12

Ah, didn’t know that!
GPS having the 2 different modes, Continuous & Fix-and-hold, how are Glonass and Galileo doing their AR?

2 Likes
13

According to the GPS setting.

3 Likes
14

Very good to know, thanks!

1 Like
15

Thanks Bide

16

Great. Thanks Igor

17

I tried Glonass AR with SAPOS data in Germany. Worked without problems.
Great improvement!

2 Likes
18

Hi everyone,

Note that we’ve also updated ReachView image in our reflashing guide to the latest version for all devices. If you need to reflash your Reach, you can flash it to v2.14 directly.

I’ve edited the original post.

2 Likes
19

16 posts were split to a new topic: Unstable Bluetooth connection

21

4 posts were split to a new topic: Missing “collection start” and “collection end” values in the csv export

23

This topic was automatically closed 182 days after the last reply. New replies are no longer allowed.