ReachView v2.11.0 can't start without sky view / connected antenna

[bide]

This question has been asked before. Reach needs an accurate time signal before starting ReachView. Your choices are:

1. Get a satellite signal by moving close to a window (like you said already).
2. Configure Reach to connect to a WiFi network that has an NTP server that Reach can get time from.
3. Use SSH to get the log files.

Reach with no Wireless network, straight hotspot on boot up

Well, ssh works, right?? You won’t get ReachView until it time-syncs. You don’t have it hooked up to a Wi-Fi network with an NTP server, so you must give it some satellites to look at so it knows what time it is. Take it to a window at least. One of the reasons it needs a time signal is for naming log files and another is for correct age of differential numbers which directly affects your ability to get an RTK fix.

Trouble opening ReachView web page

same problem as here, I can connect to the hotspot, ligth is blue / white, sometimes I can acces to the website, most of the times no. DHCP server dont provide a gateway, I try to add the reach Ip a gateway 192.168.42.1 but same issue, no web interface. I can SSH to recover my raw logs, but still, no way to get to the website. Already suffer this issue 3 times, I did 4 firmware upgrades to the latest vercion. I though it was because I did not power down Reach ok, but this last 3 times I suffer …