Reach RS+ with Reach M+

[liudmila.slepova]

Hi @normalhtswayne,

Welcome to the community forum!

Let me clarify this.

@normalhtswayne

But the rover showed only red or orange satellite bar connections, no green. Will this be a problem in post processing the data to fine tune the photo centers?

Red or orange bars indicate that SNR of the satellites is below 45. For better post-processing results, the quality of the observational data should be as good as possible. In most cases, the reason for a rather low satellite’s SNR is the issues of the antenna placement. Would you mind sharing the photos of your setup so I could check it?

@normalhtswayne

I will have the coordinates for the GCP and I read that the coordinates have to be entered as LL and the elevation as meters. There is a pulldown option that allows for X,Y,Z coordinates in feet, does that not work? I can transform my GCP to lat, long but it would be more convenient to just use the state plane coordinates.

At the moment, you can set the bases coordinates in the WGS84 coordinate system only, in LLH and XYZ format. The units of measurements are meters only.

We’re working on adding different coordinate systems support for the base as well in ReachView 3 beta version.