Navio arduplane mode

[endckr (enderC*n)]

navio arduplane mode brush motor error
help me please
error message ( Set param error )

ESC calibration problems with navio2

Image and ArduPilot version. [0503-1] Raspberry pi 2 B + Navio 2 Detailed problem description. How does observed behavior differ from the expected one? We’ve done frame class and type configuration, compass calibration ,radio control calibration in mission planner, accelerometer calibration in mission planner, and rc transmitter flight mode configuration. We tried three different methods to calibrate ESCs as follow. a.I tried the “Calibrate ESCs” in mission planner. After pressing…

[liudmila.slepova]

Hi @endckr,

Please share the following details so we could look into the issue:

• ArduPilot version
• configured parameters in Mission Planner
• screenshot of an error message

[endckr (enderC*n)]

navio2_arduplane_project.pdf (172.6 KB)

[endckr (enderC*n)]

Actually my goal is to make Y3 VTOL, I am trying to solve this error because I could not pass the first stage. Is there a document describing the GPIO pin visual or construction on navio 2.)

[liudmila.slepova]

Hi @endckr,

@endckr

Actually my goal is to make Y3 VTOL, I am trying to solve this error because I could not pass the first stage.

Have you tried to calibrate ESCs manually? Please, follow this guide to accomplish it.

@endckr

Is there a document describing the GPIO pin visual or construction on navio 2.)

We have a pinout scheme of Navio2 that you can check here.