LORA connection between RS2 and E-SURVEY GNSS

[a.billault (Antoine Billault)]

Hello,
we would like to send RTK corrections from a E300 GNSS receiver to EMLID RS2 GNSS, using the LORA radio mode.
the E300 GNSS would be the base, and the RS2 the rover.
The E300 GNSS is able to send corrections via its internal RADIO.

On EMLID side There are no PROTOCOL to set up except Db, Frequency and Air Flow, whereas for E300 (in addition to Frequency setup) I must choose a Protocol…
ESURVEY supported radio protocol includes the following:
 Satel
 PCC-4FSK
 PCC-GMSK
 TrimTalk 450S
 South 9600
 HiTarget(9600)
 HiTarget(19200)
 Trimmark III
 South 19200
 TrimTalk(4800)
 GEOTALK
 GEOMARK
 900M Hopping
 HZSZ
 GEO FHSS
 Satel_ADL
 PCCFST
 PCCFST_ADL

Do you have any idea which protocol is compliant with EMLID LORA modem ?
thanks,
antoine

[kirill.pavlyuchuk]

Bonsoir Antoine,

All of these protocols aren’t compatible with Reach’s LoRa protocol. The single workaround I can suggest is to attach external radio to Reach, which is compatible with E300’s internal radio. Reach RS2 can send corrections via Serial to external radio, then it transmits them further. You can check this topic in the forum.