No worries at all, I went through the same steps when I joined this forum and purchased Emlid equipment. They survey quite differently overseas than how we do here in The States, but I think I just about have it to where I can get the data I need keeping the majority of there workflow. Vertical is the worst transition. This would be another good resource if you are doing survey points.
The method that I use is to make separate logs for each GCP. It seems cumbersome, but when it comes to post-processing it is much faster than you would think. Basically you just occupy the point, go into logging, turn on the UBX and let it run for the desired amount of time and then turn it off. Rinse and repeat and you end up with each point ready to process against the base individually. You can use the timestamp from the GCP point to isolate the timeframe you need to process the base. Just keep track of what GCP is which log. Of course you will see that when process as well.
I want to try the point extractor as I have seen great comments, but just don’t have the time to do so right now.