Help! I'm lost! Using an RX with an RS2+ base without NTRIP

Reach RS2 / RS2+ RTK / PPK configuration
8

Hi @hicksonresearch,

I agree with the guys. Reach RX is an RTK rover specifically designed for surveying in areas with good cell and NTRIP coverage. You can use your Reach RX in one of these scenarios:

  • Connect Reach RX to any public NTRIP service. Emlid Flow uses the Internet connection on your phone or tablet to access NTRIP corrections and send them to Reach RX over Bluetooth.

  • Use Reach RS2+ as a base and free Emlid Caster as a way to send the corrections for Reach RX. You’ll need to provide both units with an internet connection.

If you’re working in a remote area, there’s no other way than to use a setup over LoRa radio. For such cases, you should use a pair of Reach receivers; all models except Reach RX support the LoRa radio. Our Reach RS2+ vs Reach RX comparison post might give more clarity.

5 Likes