Help config

Could you please post here a screenshot of you base unit “Correction input” tab?

Rtk base

Base Cero Satellites

Hi Luis,

Please follow the steps outlined in this video:

I Cant see My problem in lora corrections

Luis, please take a look at this post from Tatiana:

is disable it
No found

Is this photo from rover or base?

I managed to make it work, now I’m trying to see why the SurvCe only recognizes GPS satellites


What’s the version of SurvCe you use? Could you please share your current system report?

Hello Tatiana
Survce V 3.02


It’s possible that the issue appeared because Reach is fully supported in SurvCE only from 5.06 version. Have you tried to reach out to SurvCE support? Maybe they can help.

Thank you Tatiana! What would be the best way to pass geographic coordinates to flat Gauss Kruger coordinates of Argentina?

Hi Luis,

I think you can use any online converter.

hi Tatiana, I am converting coordinates in autocad from lat long to Posgar 98. but the problem is then to stake out from N, E, Z to lat long. I hope they can put in the Rechview to configure local coordinates. Thank you

This topic was automatically closed 100 days after the last reply. New replies are no longer allowed.