Yes, antenna height is very important even if are not concerned about elevation measurements. It’s how it all works together by triangulating calculations.
See figure 5. Height from point on ground to bottom of reach rs PLUS 65mm is antenna height.
GLONASS AR off. (Just a recommendation by a Emlid person here via posts)
There are some minimum settings to try first to see how things go, then add as u go if need certain settings.
It would be nice if these “default” or initial settings were in a FAQ to eliminate constant asking about it by each new user. I am one of those. We all were/are. These recommended settings are scattered throughout the forum… so searching and reading helps greatly.
The solution status was FLOAT most of the time…has to be FIX to repeat accuracy.
You need to get your settings more in line to get constant FIX if you want exactness. I saw some SINGLE popping up in video also. Several times FIX popped up.