Update and wifi connection issue with Reach and dev. 2.21.1

There is a tooth wheel in top right corner in the menu to the left. Try that first.

I assume you refere to the Control panel.
Hvis is screen shot of my control panel, and I do not see any thing regarding dev. updates

I see. Then your are left with downloading the dev. file and flash it.
The one to the right in the link below
https://docs.emlid.com/reach/common/reachview/firmware-reflashing/#reach-rs-rtk-firmware-download

Edit: @Emlid, is this a new bug? I reckon updating from 2.20.8 to dev before. ref link below

Thanks, but is still making problems.

I have now flashed the dev. to the Reach RTK. but one “accident” does not come alone!
After the new flash, will it not connect to my wifi! (It worked fine before)
I have now tried to connect it 10 times, either by configuring it in the app or browser.
So i cannot get access to the internet, and there by not update… ?

You can connect to Reach hotspot?
Do you have the antenna connected?
Does it help if you have the antenna i somewhat clear sky to let it sync
If you add :5000 at the end of the IP adresse, what do you get?

Edit: One more thing, is your Wifi handing out IP addresse in the range of 192.168.2.xxx ?
If so, try share wifi with your phone and let Reach connect there instead

If your Reach is not connected to internet, it will not inform you of updates.

sorry. I wasn’t specific enough.

The reach create a hotspot, that I can access. So this works fine.
I connect to it over :5000 and configure the wifi I want it to access, and press connect. It then close it own hotspot for a while (2min), but then it opens it own hotspot again.

  • I’m using my iPhone as hotspot and it hands out IP: 172.20.10.x on subnet 255.255.255.240

  • Yes, the antenna is connected.

  • No, right now i’m indoors, but this worked fine in the non-dev. firmware.

And you have tried turning the power off for Reach for few minutes and then on again after wifi has been added?
On your phones, do you see it connect before it drops the connection?
You have tripple checked the password is correct typed in?
Try changing wifi password to something different and simpler

I have already tried all the idears you mention here.
Non of it works.

And, no. I don not see it connect before it drops the connection.

This part here. Is that how you configure it each time? Not through the Reachview menu?
Oh, and are you Norwegian? It stats Ons in the display

menu? i have used both the app and browser.

hehe. almost. i’m danish. :slight_smile:

I`ll try my own unit later and see if it will act up too.

Cool.
I have now downgraded it to v2.20.8 and the wifi is working fine now.

Updated Reach from 2.21.2 No issues here
Was running 2.21.2 thoug


1 Like

Did the same this morning without any problem .

1 Like

From 2.21.2 ?

I am talking the RS2 now , I just reread the top it talking about reach. My bad :sleeping:

Reflashed with downloaded image 2.21.1. No issues.
Then updated to 2.22.0. No issues

2 Likes

Hi there,

We’ve just updated the Reflashing guide in the docs with links to the v2.22.0 firmware image. Please check it by following the link.

To update Reach RTK or Reach RS from v2.20.8 to v2.22.0, the device should be reflashed.

Thanks!

1 Like

4 posts were split to a new topic: Can’t reflash Reach RS+

This topic was automatically closed 100 days after the last reply. New replies are no longer allowed.