The scheme of the power supply Emlid M2 and Pixhawk Mini 6C

Reach Module / M+ / M2 Hardware integration
1

Here: Power supply | RTK Modules
the information is passed „To notes plug two power supplies at the time himself the ace it may damage the device.”

  1. Reach M2 / M + JST-GH 6p-6p cable for Pixhawk. The removal of the cable “+ 5V” is he the correct solution?
  2. Reach M2 / M + JST-GH 6p-6p cable for Pixhawk. Should you leave the cable “GND” ?

schemat.pdf (359.0 KB)

schemat
schemat1920×2715 144 KB

3

Hi Pawel,

We haven’t tested such a setup, but I believe you’re right. You need to remove the 5V and leave the GND.

5

I checked. This solution works correctly.

1 Like
6

This topic was automatically closed 100 days after the last reply. New replies are no longer allowed.