Sending message with mavproxy (servo)

Navio / Edge Getting started
1

Hi

I have a problem with servo when ı sent one more than message MAV_CMD_DO_SET_SERVO , ı observed only one command running after another command not running and mavproxy connection automatically lost after 10 seconds heartbeat was coming. how to sent servo command a different way or this way correctly

3

Hi @EmreEngin,

Can you please explain the setup steps you perform for transmitting signals from GCS to your drone controller?

If you need to cycle this command, try using MAV_CMD_DO_REPEAT_SERVO message. Here you can read more about its parameters.

5

This topic was automatically closed 100 days after the last reply. New replies are no longer allowed.