RTK Workflow needed for Known Points in NAD83(2011)

[jaja6009 (Jamieson Allen)]

I just read and digested an older thread on Reachview 3 on its journey through Beta, very interesting.

I found in that thread where an Emlid developer says you can just enter NAD83(2011) into the base Manual mode, or at least that is what I am getting from his statement.

ReachView 3 Beta

Yes, you can just enter your coordinates in NAD83 into Base Mode and use it. I’m not sure what do you mean under scale factor, but I suppose it’s projection parameter. Take a look at this example of projection, there is scale_factor=0.99996. You don’t need to worry about it when you entering your base position since it’s projection parameter related to the certain State Plane CRS, not to geographic NAD83, and it will be automatically applied by RV3 during transformation. NAD83 has LLH position…

I also found this is Reachview 3 Docs Section, Reachview 3, Working with coordinate systems, United States

USA | Emlid Flow and Emlid Flow 360

So, Reachview 3 will let me enter NAD83 (2011) into the Base Section as long as I chose it as the coordinate system when I start a project?