RTK with RS2+ - Rover receiving corrections, but stuck in single

Reach RS2 / RS2+ RTK / PPK configuration
1

Hello,

I recently received two RS2+ units (firmware is v31.8). I am attempting to perform base and rover RTK with the base on a surveyed point. I set the base to manual and input the surveyed coordinates. I set both base and rover to LoRa on the same frequency. The rover is receiving corrections, but is stuck in single. I’ve tested it several times and was able to get it to fix once, but haven’t been able to replicate that. I’m setup on a roof with excellent sky view.

CorrectionButSingle
CorrectionButSingle1170×2530 110 KB

Any advice appreciated. Thanks.

3

Hi Brennan, Welcome to the community!

It shows that the rover is receiving correction but still in a single solution. Could you try to set up the base position with averaged single and see if you can get Float or Fix with it?

5

This topic was automatically closed 100 days after the last reply. New replies are no longer allowed.