RTK inject trough HERELINK radio protocol to emlid M2

Reach Module / M+ / M2 Hardware integration
1

hi there, im wondering if any of you know how is the procedure to inject RTK coordinates if you are using the new profiCNC controller HERELINK?
is there any problem?
extra steps?

thank you very much

3

Hi Fran,

As far as I see from the datasheets, the Herelink controller is compatible with Cube, Ardupilot and PX4 autopilots, that is why there should not be any issues with such a setup.

Regarding the configuration of M2, there should not be any additional steps needed. Our guide on the integration of M2 with autopilots might be of help here.

4

thank you Artem, we are looking to test the two hardware together very soon, and knowing this is very helpful

6

This topic was automatically closed 100 days after the last reply. New replies are no longer allowed.