Rs2+ (base) and Trimble R780 (rover) with Emlid Caster

Has anyone had success with using a RS2+ as a base, and submitting corrections to a Trimble R780 (or similar i.e. R8, R12 etc) via the EMLID NTRIP Caster? I understand I will likely have to use a legacy format like RTCM3, but beyond that, I have drawn a blank.

1 Like

Hi @pj.fassam ,

Welcome to our community! Sorry, it’s been so quiet here.

As far as I know, the Trimble R780 has internet access and supports the RTCM3 format, so it should work well as a rover using Emlid Caster. You should just connect your rover to the same mount point as your Reach RS2+ base.

This topic was automatically closed 100 days after the last reply. New replies are no longer allowed.