I’m having a similar problem and thought I’d tack on to this thread.
I was using image 1.2 with app 0.4.9. I connected to my laptop via USB and ran the flashall.bat - this appeared to work fine.
I had to change the usb0.network address to 192.168.3.15 from 192.168.2.15, since my local subnet is 192.168.2.*. (see post here: Reach - can't connect to ReachView app (firmware 1.2) [solved - network address])
I was able to see the Reach module in hotspot mode. I connected to its WiFi network, then added my local WiFi credentials. I then clicked “Connect”. After that, I can’t reach the Reach.
I’ve powered down and powered up a few times. I can’t see the module with Fing. The module’s LED status (after the module fully boots) alternates from magenta to green.
How should the troubleshooting proceed? I could try re-flashing…?