Hello all.
Using a pair of Reach modules for a project that needed updating from v2.3. One updated no problem and the other is failing on test 2 and the receiver update.
After a few reboots the test 2 was able to pass and the ReachView update was able to go through. The receiver update was still failing however. I figured I could live without this update but test 2 still fails most of the time upon power up which prevents me from using the module.
I tried reflashing the Edison with the provided image on the docs. The problem still persists. I’ve also tried updating while powering through the DF13 and again through the micro USB (but never at the same time).
Does anyone have some troubleshooting ideas?