Reach RS and Reach M+ connections

[bide]

OK, if you are going to be doing PPK then you don’t need to set up base corrections because they are for RTK.

You can review this guide:

HowTo: ReachView settings for PPK

The purpose here is to show you the basic ReachView settings for PPK. I have provided screenshots of each tab within ReachView and annotated them in RED writing. We will not discuss post-processing here, only ReachView settings. NOTE* The settings below are exactly the same for base and rover. That is because the choice between base and rover is something that is done afterward when you post-process your log files. At the bottom of each picture, I have rewritten the English text for people wh…

But the basic needs for PPK data collection are:

1. Select the GNSS systems you want to use (constellations).
2. Select the sample rate (the update frequency in Hz).
3. Make sure the raw data log is turned on.
4. Optionally, you can select a RINEX version for the automatic raw data log conversion.
5. There is no base and no rover for PPK. Configure all your devices the same. Later during your post processing you choose which one is acting as base and which one is acting as rover.