Is the recommended ground plane size the ACTUAL size you want? Or is that size considered a minimum size needed? My current ground planes(base/rover), are made from abs plastics and then wrapped in a copper tape and have a diameter of 6.25”(158.75mm). I was going to redo them and make them a littl…

Looks good to me. I really like the radome. The acrylic, if it is equal thickness all around and equidistant from the antenna, then it will only have a small bit of signal attenuation. I see small wrinkles in the copper tape. Probably not a big deal, especially if they are radial from the center…

Random ground plane question

Reach Module / M+ / M2 Getting started

bide August 12, 2018, 7:10pm 4

Found that old thread:

2 Likes