Hi Everyone,
I’m having problems with my base correction connection in NTRIP. I input the data (see image), it connects, but after 10 seconds it changes to “Timeout” for a few seconds, then connects again, but after 10 seconds changes to “Timeout”, and on and on it goes. I had it outside with a clear view of the sky for 10 minutes and it was still on “Single” for solution status. Does anyone know why NTRIP would keep timing out? I’m guessing this is why my solution status is not getting any better, but it may be 2 separate problems…
I dont think its properly configurated to begin with.
What service are you connecting to? (webpage with spec)
This topic was automatically closed 100 days after the last reply. New replies are no longer allowed.