Emlid

Community Forum

Navio2 not connecting to Mission Planner


(Stanley.dt) #1

Hi,

This is very new to me and I hope I can get some help. I’m trying to setup my Navio2 on a raspberry pi 3. I’ve followed the steps in the documentation but for some reason Mission Planner does not want to connect.

Here are all the steps I’ve been following:


(Tatiana Andreeva) #3

Hi @stanley.dt,

As I can see from the screenshot, the IP address of your RPi is 192.168.0.124, and the same address is configured in /etc/default/ardurover. Please make sure that you specify the IP address of the GCS computer in the file, not the RPi IP address.

Hope it’ll help!


(Stanley.dt) #4

Thank you, that did the trick. Very new to this but now its working fine.

Now I can continue building it into my test Rover.


(system) closed #6

This topic was automatically closed 100 days after the last reply. New replies are no longer allowed.