Navio2 MPU9250 Magnetometer data output is 0 0 0

Hello,

I was working on the Navio2 sensor Mpu9250 to do some Inertial Navigation analysis. The sensor was working fine as I was able to get data of accelerometer, gyroscope and magnetometer. However, after a while of use, the magnetometer now gives no data. It just plainly publishes 0, 0, 0 when using the AccelGyroMag.py file from Navio2 docs. I tested the lsm9ds1 and it works fine. Any idea to reset the MPU9250’s Magnetometer?.

Kindly, help me.

Thanks,
Lazy12316

Hi,

Had you tried running this example from this guide? Could you please share the photos of your hardware setup and the screenshots of the 3dimu.py?