Migrating Ardupilot settings to new image

I would like to avoid re-calibrating radio, sensors and other Ardupilot-specific settings when installing a new image to a new SD card.

I was thus wondering if there is a way to migrate Ardupilot-specific settings from one image to another (i.e. from one SD card to another, both containing the Emlid image) ?



From Mission Planner “Config/Tuning” screen, Full parameter List, you have Load Save Buttons.

Save to save your params to disk,

Load to read from disk then Write to write them on the new SD Card.



@mlebret brilliant, thanks a lot!