Hello, I have the same problem. One of my Lora’s looks not connected on correction input and it’s orange rx light is always on. I have tried switching my rtk’s (two reach m+) and cables for the Lora’s however it stays not connected.
I just found out that the voltage regulator on the board is broken. I’m gonna buy a new one.
Hi Eren,
Welcome to our community!
Let’s take a closer look. Can you please share a photo of your setup with the two Reach M+s and a screenshot of the Correction input screen in Emlid Flow for them? Do you see the message “Not connected” for both units?
Why do you think it’s broken? Did you experience anything related to it?
A post was split to a new topic: Rover doesn’t connect to the base
This topic was automatically closed 100 days after the last reply. New replies are no longer allowed.