LeddarOne Range FInder - Navio2

Navio / Edge Hardware
1

Linux navio 4.14.95-emlid-v7+ #1 SMP PREEMPT Mon Feb 4 15:59:56 MSK 2019 armv7l

Trying to add a Leddertech LeddarOne range finder. I have it connected to the UART port on the Navio2 board. However, when I goto the setup tool, select range finder and pick LeddarOne, distance and voltage both show 0.

If I connect the unit to my pc and run their software, it does properly work so I know the unit is good…

Thoughts?

3

Hi Tommy,

May I ask you to share your hardware setup photos?

Have you tried to configure it as it’s explained in the ArduPilot docs?

5

This topic was automatically closed 100 days after the last reply. New replies are no longer allowed.