How to get MPU, LSM, and GPS Readings in pi3

I have connected my Navio 2 with pi3 and tried to access MPU, LSM and GPS sensors. then it says sensor not enabled, but when using pi2 it is working properly. the commands I used and result I got are below. when using pi3 do we have to enable sensors? can someone help me?

Thank you

Hello and welcome!

There’s hardly any software reasons for that. Are you screwing the board down properly? Otherwise, the only explanation I have is a faulty SPI (all examples you listed use this bus) on Raspberry Pi 3. Do you have other RPi3? There’s been reports about faulty ones.