Hi everyone,
I have two modules RTK Reach, one over a rover and the other in an static base.
I would like to know if there is some way to get position rover data with and without correction at the same time in kinematics mode?
Thanks
Hi everyone,
I have two modules RTK Reach, one over a rover and the other in an static base.
I would like to know if there is some way to get position rover data with and without correction at the same time in kinematics mode?
Thanks
Not within Reachview.
But if you run RTKnavi you could have one service running single and the other kinematic.
Forward observation from base and rover to a computer running RTKnavi.
This topic was automatically closed 100 days after the last reply. New replies are no longer allowed.