Firmware v30.1

Before creating a new thread, please refer to Quickstart guides for Reach RS2/RS2+, Reach RS/RS+, and Reach Modules.

In case you are creating a thread about an issue please specify the appropriate sub-category first!

I have updated my Reach RS2 with the latest firmware v30.1 and it keeps failing the install. It will boot into operational mode and I can set it up but when I power it off it will not restart, just keeps cycling.

Hi Terry,

What happens if you turn the receiver off by pressing the power button for 15+ secs and turn it on again? Can it load properly? If the LEDs are still blinking, please place the unit on an overnight charge (at least 9 hours) and try to reboot it after that.

Also, please let me know if the receiver’s network LED is blue, white, or off.