Emlid NTRIP Caster

Emlid NTRIP Caster Getting started
15

Hi @kvand,

Let me sum up the info in this thread.

To configure the connection with Emlid NTRIP Caster, you need to do the following:

  • go to the Base mode tab on the base’s ReachView
  • choose NTRIP as Corrections output
  • enter all the necessary credentials: IP address, password, port, and mount point for the base
  • go to the Corrections Input tab on the rover’s ReachView
  • choose NTRIP as Base correction
  • enter all the necessary credentials: IP address, username, password, port, and mount point for the base

After this, your base and rover should be able to transmit/receive the corrections via the allocated mount point.

Please, keep me updated on whether it works for you.

I’d also like to thank @TB_RTK and David for the input.

2 Likes