Hi Andrew,
We have this guide explaining more about post-processing using Emlid Caster.
I checked the files you sent here, and we advise following the workflow below to post-process your data in Emlid Studio.
- Static processing to obtain the precise position of the Reach receiver
- Drone processing using the reach receiver as the base
For the first part of the processing:
You will need to attach these two RNX observation files. It should look like this:
HOND00ESP_R_20241761000_01H_01S_MO.rnx
The two RNX files for the base weren’t visible, so convert them to RINEX before dragging them into the base section on Emlid Studio.
On Emlid Studio, in the configurations part, set the elevation mask to 20 and the Combined filter type option.
You can use the navigation file from Reach the one with the end _MN.rnx is the navigation file.
For the second part:
We found this thread on the DJI forum that you can rename the .RTK file to .RTCM3 since it contains the raw data.
The reason to rename the files is because the Emlid Studio only supports these extensions of files:
To the drone processing on the Emlid Flow app follow these steps:
- To rename the files, right-click on the .RTK file > get info > change file extension to RTCM3.
- Then, convert the RTCM3 file to RINEX.
- Proceed with the drone processing on Emlid Studio.