Hello,
I’m having an issue with the Navio 2 receiving or showing RC inputs. I currently have a FrSky Delta 8 with the CPPM connected to the Navio. And when I go to the initial setup and to the radio calibration, there are no RC inputs shown. I checked that all the correct pins are connected and that the transmitter I’m using (Taranix X9D -plus) is connected to the receiver. I’ve ran the following commands on the raspberry pi:
cat /sys/kernel/rcio/status/alive
=> 1
cd /sys/kernel/rcio/rcin
sudo cat connected
=> 0
Any suggestions on what could be the issue? Thanks.