Cannot connect to Reach through ReachView

Reach Module / M+ / M2 Getting started
1

Hi,

I have configured my four Reach devices. All went fine through the setup process (although I had to flush my browser cache/autofill every time for the device to detect local wifi (otherwise it would remain “scanning” forever).

Now I have hooked them all up to my local wifi and can connect to them over IP address, except for one device. For this device the LED doesn’t blink but remains BLUE. I tried to reboot, but still the same… I cannot find any documentation on a static BLUE led in the troubleshooting. Please help.

Thomas

2

Hi Thomas,

It has been a while since we have shipped these modules and firmware has progressed. Could you try updating to the newest image?

3

Just did. Flashing was successful. Now it works!