Camera triggers detected but same coordinates calculated

Reach Module / M+ / M2 Hardware integration
1

Hi,
I am using Reach M+ to record raw GNSS data for PPK for photogrammetry missions and hot shoe cable to record camera triggers.
Number of events and number of planned and captured pictures matches but time to time I get some events with exactly the same coordinates even thought pictures are captured couple of meters apart.
I guess I can rule out HW problem (camera setting, wiring, bad contact…) otherwise number of events would not be the same as captured photos, but then explanation for this issue is harder… any idea?

Thanks Jakub

4

Hi @jakub.jon,

You can double-check your setup according to our recommendations for Reach M+ mapping setup and specific requirements for GNSS settings on Reach M+.

If you still have events with the exact coordinates after all modifications, please share your data set including photos and raw data to support@emlid.com for analysis.

1 Like
6

This topic was automatically closed 100 days after the last reply. New replies are no longer allowed.