Recovery of RS2 RTCM3 base station data to send correction to external gnss rover

[williamstark]

My RS2 is version 27.0 and Emlid Flow is 13.3

This isn’t really an issue but more of a question for integration and how to obtain rtcm3 to send to a rover sensor. I have a VN-210 sensor, this sensor can automatically detect RTCM3 messages when sent to it by a serial port to adjust its GPS coordinates. Resolving how to give the RTCM3 data to the VN210 will be a problem for another day hahah, but I would like to understand how to get the RTCM3 data from the Reach RS2 and use it based on your knoledge of how RTCM3 is usally given to external gnss’s that aren’t a part of the emlid family. I am extremely new to this product. I have read a bit, but I don’t understand how the RTCM3 data should processed or sent by other means than the emlid app which does it automatically for it’s products. Sorry for my lack of knowledge about this subject.

Should I save the RTCM3 data equired to my ground station computer and then send it to my VN-210 gnss by radio com. the VN-210 is linked to an orangepi 5B by USB. Or is there a simpler way of doing this integration.

[ruth.bongon]

@williamstark,

Welcome to the community.

First, I want to say that your receiver’s firmware is outdated. Please follow this guide to update it to the latest stable version.

Base corrections can be sent via several methods, as in the screenshot below.

Only the LoRa method is exclusively for Reach devices. I’m not familiar with the hardware you want to integrate it with, but you can send the corrections to any third-party receiver using the other methods.