ReachRS fails "Test2" on boot

Every now and then when I log in to my ReachRS I get this screen.

The only way I’ve found to fix this error is by rebooting. What is “Test2” and can I prevent this errror from occurring?

Regards, Ben

I’m not sure what “Test 2” is, but I had this same issue a couple of times. Turning the unit off and on again usually helped.

Test 2 means the internal receiver. How often does this happen?

No very often. About three times in total.

Ok, good to know. We know about this, but, unfortunately, it is really hard to recreate this state. I will figure this out as soon, as I get the chance.

This topic was automatically closed after 100 days. New replies are no longer allowed.