Reach View or Other Surveying Software

On a general not about autocad360, my experiance is this:
-If file is not geolocated properly and you need to set a point on drawing as “set location”, you also need to be aware of north direction and ppm deviation.

In my case i use UTM32 and placing a sitemap, i would set north direction +3 degress and adjust a scaling factor of UTM 0,9996. If not scaled, ppm would deviate 4cm for every 100m from your “set location” point.

Link to utm scaling and direction explanation - Universal Transverse Mercator coordinate system - Wikipedia