Reach M2, NMEA sentence setup

Reach Module / M+ / M2 Getting started
1

Is there a way to modify the NMEA Message output ? Selecting only $GNGGA for exemple.
(output on S1 / Serial , Uart , Nmea)
Thanks a lot.

2

Hi Fredo,

In the meantime, there’s no way to configure NMEA output. However, the external device still should work, it should just use the required message.

3

Thanks for your answer. Our external app will manage.

4

This topic was automatically closed 100 days after the last reply. New replies are no longer allowed.