Emlid

Community Forum

Navio / Edge   Getting started


Getting started with Navio+/Navio2 (1)
Navio2 can't connect after Arduplane update (1)
Mission Planner connection problem ( 2 ) (30)
Navio2 + Reach - 2nd GPS question (10)
Segmentation fault when communication (6)
Getting servos to actually move (Navio2) (4)
Radio Stick calibration error? Sticks are not in the middle (4)
Control the Navio2 without an RC (2)
Emlidtool newbie - how i can use emlidtool? (6)
Setting communication to UGCS, which connection settings? (3)
Emlid Edge: Critical: PreArm: GPS horiz Error (2)
Which firmware is recommended for EMLID Edge? (2)
ESC calibration problems with navio2 (18)
Cannot write dataflash logs (4)
Problem with ardupilot (3)
How to write a python script on NAVIO/ raspberry pi 3 (6)
How to get measures of Navio2's sensors in a C(not C++) program (2)
I cant get the motors to respond to Servo.py (17)
Speed Controller and Navio2 Protocol Issue (13)
Cant't arm/takeoff due to bad compass health (12)
How to arm the motors without radio transmitter/receiver? (2)
Battery Voltage (2)
QGroundControl & Navio2 connecting issue (6)
No more access via ssh after connection to Mission Planner (7)
Arrow indicator on Navio Power module? (4)
Use external state estimation node for ardupilot (3)
Unable to calibrate ESC on Navio2 (3)
External Compass Calibration Fails - Unexpected Error (2)
Sending low level manual flight commands to navio2 board (2)
Navio 2 - Run Pytho scripts for sensors on a Raspbian Stretch (4)