Ground Control Points with one RS

[TB_RTK]

@sachel85

Is it possible to get by with just one rover to set ground control points and post process them afterwards

Yes, but you need correction data (downloaded from a service f.e.)of some sort so get cm accuracy

@sachel85

If it is possible to use just one, what kind of accuracy are you seeing?

Cm accuracy is possible

@sachel85

If using only one RS is a possibility could someone share how they post process their points for accuracy?

Just another day at the office #1. Sitesurvey with Reach, autocad360 and CPOS

I thought i share a old survey job i did on one of our contruction sites. Gear i used: 1x Reach in one of mye DIY survey poles 1x Phone with hotspot, lefebure ntrip, autocad360 and connection to internet 1x CPOS ntrip, provider of correction data (VRS base) 1x worksheet with predefined points to survey, and some to collect and adjust From the video below i started out in the terrain over a fixed offical known point to geo ref. autocad360. I then stared walking towards the site area to do…